I haven’t posted in a while, so let’s start this set of upcoming posts with a super useful item. A door draft blocker! I needed two for different reasons. First, the block the beer closet from getting dust, pet hair, and other items into the precious beer area. The second is to keep the kitty litter in the cat closet. Sometimes he is messy and gets the litter everywhere! Then we tread on it while walking down the hall, it’s the worst.
- Measure your doors! The beer door is 30-inches, the cat door is 24-inches and the width of both is 1 1/4-inches
Length, is obviously just a bit longer than the length of the door. I did 26-inches on the brown, for the cat door and 34-inches on the gray for the beer door.
Width is 15 inches: 1/2 inch on each side for seams, 6 inches on each side for the stuffing and a middle section 2 inches long.
3. Seams: I did the seams two different ways to see which I like better, time will tell.
For the gray I did a serger edge on each of the long lengths. Always finish serger seams with some fray check.
On the brown fabric I did a folded over seam. I ironed a 1/4-inch fold on each long edge.
4. Pin: Fold each side in on the long length. For the folded edge, ensure to keep the edge folded while pinning. I left an approximate 1-inch gap between the fabric.
On one of the short edges fold under the end to seal the end, leaving the other end free.
5. Sew. For the serger edge, sew at the inside edge of the serger thread. On the folded over edge give a little less than a 1/4-inch seam allowance.
Sew the folded under short edge closed.
6. Stuff and seal closed. The obvious stuffing material is the acrylic stuffing that you can buy from the store. I stuffed these with old clothes that weren’t going to make it to the thrift store. Always cut off buttons, take out zippers and save those!
7. Apply to the door.
In use on the beer closet:
In use on the cat closet.